Download Adding Touch Screens to Projects and Prototypes Course for Free

The touch screen we use in the course - Part 1

The touch screen we use in the course - Part 2

The development board we use int eh course - Part 1

The TTL to USB module we use in the course - Part 1

The development board we use int eh course - Part 2

The TTL to USB module we use in the course - Part 2

The Nextion IO adaptor we use in the course - Part 1

The Nextion IO adaptor we use in the course - Part 2

Downloading and installing Nextion Editor

Bezel for the screen

Explaning Nextion Editor interface - Part 1

Explaning Nextion Editor interface - Part 2

Explaning Nextion Editor interface - Part 3

Changing attributes of a text box with a touch

Adding and using fonts

Scrolling text box

Number box

Using buttons

Using Dual State buttons and Timers

Receiving data on the screen

A bit more about the NExtion Editor interface

Sending data from the screen

Introduction to the course

Course plan

GPIOs of the Screen

GPIOs as Output - Diagram and configurations

Testing the LED project

GPIO as Pulse Width Modulation PWM

Controling an LED from screen - Setting up the project in Nextion Editor

GPIOs as input

Implementing the project in Nextion Editor - Part 2

Implementing the project in Nextion Editor - Part 1

Testing the Project - GPIO as PWM

Creating an animated guage - plan and graphics

Creating the animated guage - Part 1

Creating the animated guage - Part 2

Creating the animated guage - Part 3

Testing the project

Project oerview

Project layout and plan

Creating Page 3 in Nextion Editor

Creating Page 1 in Nextion Editor

Sending the project to the screen

Creating Page 2 in Nextion Editor

Explaining what to change on screen when we read the battery value

Explaining the change and the code plan

Code plan - Part 2

Code plan - Part 1

Code plan - Part 3

Code plan - Part 4

Setting up the project in CubeIDE - Part 1

Setting up the project in CubeIDE - Part 2

Setting up the project in CubeIDE - Part 3

ADC reading table

Solving and understanding ADC reading

ADC reading from the battery and the battery ranges

Connecting UART 6 on the Nucleo board

Implementing the function in the code

Including the battery reading in the code

Final code debugging and testing